In-stock parts
Order by 2PM MST
In-stock parts
Order by 2PM MST
Images are for representation only and may differ from the actual product.
Usually ready in 2 hours
2045 West Buckeye Road
Phoenix AZ 85009
United States
Coxreels 8954 bearing assembly supports the axle at the inline-swivel end of compatible 1185 hose reels, including 1185-1124 and 1185-2024 hand-crank reels and their motorized versions. Its housing receives the flanged end of the matching inline swivel. One bearing assembly is supplied; the swivel, retaining plate, washers, rings and mounting hardware are separate components.
An inline 1185 reel uses different bearing assemblies at opposite ends. Match the existing swivel-side assembly before ordering: 8954 is the inline-swivel selection, while 8166 serves a different position and is used at both ends of the optional 90-degree-swivel arrangement.
| Feature | Benefit |
|---|---|
| Swivel-side bearing assembly | Supports the axle and locates the flanged inline swivel within the bearing housing. |
| Replaceable assembly | Allows a targeted repair when the surrounding reel components remain serviceable. |
| Specification | Detail |
|---|---|
| Manufacturer and part | Coxreels 8954 |
| Component | Inline-swivel-side bearing assembly |
| Reel family | 1185 with the matching inline axle and swivel |
| Typical models | 1185-1124 and 1185-2024, including motorized versions with matching inline components |
| Quantity per compatible reel | One 8954 assembly |
| Separate related parts | 8970-family swivel, 8956 retaining plate, 8960 and 8960-1 washers, 20252 retaining rings and hardware |
| Check | Requirement |
|---|---|
| Existing assembly | Confirm complete reel model, revision and swivel configuration. Check the bearing at the swivel end; do not substitute by appearance or plumbing size alone. |
| Older or modified reels | Verify the installed axle and swivel match the 8954 arrangement before ordering. |
| Safe service | Have qualified personnel disconnect the pressure supply, release line pressure and isolate any motor drive before service. Follow the applicable reel assembly drawing. |
| Installation checks | Align the bearing blocks, fully seat retaining rings, and fit the thrust washer with its coated side outward. Maintain the required 1/16- to 1/8-inch clearance at the opposite bearing-block end. |
| Related wear | Inspect the separate washers, rings, swivel seals and hardware before reassembly; replace worn parts as needed. |
Need help confirming the correct bearing assembly? Contact UnitedBuilt through online chat, email parts@unitedbuilt.com, or call 602-253-7750 with your reel model, revision and photos of the swivel-side bearing.
| Country of Origin | USA (subject to change) |
|---|---|
| Weight | 1.49 lb |