In-stock parts
Order by 2PM MST
In-stock parts
Order by 2PM MST
Images are for representation only and may differ from the actual product.
Usually ready in 2 hours
2045 West Buckeye Road
Phoenix AZ 85009
United States
The Parker 63PT-10-62 brass tube insert supports industrial thermoplastic tubing at a compatible compression connection. It is sized for 5/8-inch tube outside diameter and a 0.062-inch wall, so both measurements matter when selecting a replacement.
This is a tube-support insert, not a complete compression fitting or sight-gauge assembly. Pair it with the correct fitting body, nut, and sleeve for the tube material and service. A matching outside diameter alone does not establish fit when tubing wall thickness differs.
| Feature | Benefit |
|---|---|
| Internal tube support | Supports the tubing within the compression connection. |
| Wall-specific sizing | Matches 5/8-inch OD tubing with a 0.062-inch wall. |
| Separate insert | Allows selection of the support component without treating it as a complete fitting. |
| Specification | Details |
|---|---|
| Brand | Parker |
| Manufacturer part number | 63PT-10-62 |
| Component | Tube-support insert |
| Material | Brass |
| Compatible tube OD | 5/8 inch |
| Compatible tube wall | 0.062 inch |
| Nominal length | 0.72 inch (approximately 23/32 inch) |
| Insert outside diameter | 0.483 inch |
| Check | Selection guidance |
|---|---|
| Tubing dimensions | Verify tube OD and wall thickness; 5/8 inch describes the tubing, not the insert outside diameter. |
| Compression components | Use the matching body, nut, and sleeve specified for the tubing. Confirm the sleeve required for thermoplastic tubing. |
| Replacement selection | Match Parker 63PT-10-62 and dimensions rather than relying on an alternate number alone. |
| Service conditions | Confirm fluid, pressure, and temperature suitability for the complete tube-and-fitting assembly; an insert alone does not establish an assembly rating. |
| Installation | Isolate and depressurize the system before service. Tubing and other compression components must be selected separately. |
Need help selecting the correct component? Contact UnitedBuilt through online chat, email parts@unitedbuilt.com, or call 602-253-7750 with your tube outside diameter, wall thickness, and existing fitting number.
| Material | Brass |
|---|---|
| Country of Origin | USA (subject to change) |
| Weight | 0.0 lb |
| Alternate part number |
|